Last night i clamped down the crack from the steering box and welded it up, frogot to snap a post pic....
Then i got the bel-tek spindles pulled off of my truck and mocked up the front end....
I got more then i bargained for out of the front end drop, originally i planned on the lca pivots sitting ON the pack of ciggarettes, and worried about being able to make it that low, but ended up sitting on the ground... wich is fine by me
And the only problem i have noticed thus far is the driver side bag rubs ever so slightly on the back side of the cup i made.... i can't figure out why though i measured the two lca's against each other and they are fairly identical with in a 1/32 of an inch, but i determened that isn't enough to effect the problem so.... i'm planning on modifying the upper bracket to get me where i need to be, as that is were i believe the problem is...
Any who pressing on i'm starting to build my rear notch tonight and should have some pics come monday... later