View Single Post
Old 02-07-2009, 09:41 PM   #3
SCOTI
Registered User
 
SCOTI's Avatar
 
Join Date: Apr 2001
Location: DALLAS,TX
Posts: 22,136
Re: Anybody Using CPP's Super Trac Bar

Quote:
Originally Posted by royo View Post
I used a ece bar no problems
Has ECE changed their pass side mount?

The reason I ask is because CPP was the first to make that style trailing arm bracket (captures the trailing arm on the top & bottom). I have yet to see anything on ECE's site w/an image similar to that.

I was going to use the CPP style (like in those pics) but already had the long Panhard bar & only needed that specific trailing arm bracket (that's thier 'new' version). When I called them to see which style I would get if I ordered one (new or old), they didn't know (couldn't tell me) which one I would receive. I then inquired about purchasing just the trailing arm bracket by itself & they wouldn't "break up a set".

I built my own.

Jholley, I would speak w/someone from CPP's tech group & verify if the dimensions on your bracket are correct. You shouldn't need to 'crush' the bracket or 'shim' it to properly tighten it up.

Here's a pic of ECE's 'Super Track-Bar' kit . . ......
Attached Images
 
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG

Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....

Cubic inches is like Indiana Jones with a cheap pistol.

Last edited by SCOTI; 02-07-2009 at 09:45 PM.
SCOTI is offline   Reply With Quote