|
Re: Anybody Using CPP's Super Trac Bar
Quote:
Originally Posted by jholley
I'm just curious if there is supposed to be this much gap in the bracket that goes around the trailing arm and if so am I supposed to just cinch up the bolts and crimp it up or shim it out with some washers.
Also, do they only ship one length of U-bolt with their drop block kits? Note all the extra bolt I have after installing the 1 1/2 blocks. I'm going to have to cut the extra off I guess.
|
Maybe it's made for a 3/4 ton truck? There are reinforcement plates on the top and bottom of the heavy truck arms that would make up that difference. Their U-bolts are stupid long- just put a set on a buddy's truck- gonna have to cut 'em...
Quote:
Originally Posted by royo
I used a ece bar no problems
|
That's a CPP bar...
__________________
-Chris
Instagram _elgringoloco_
'70 Short-Wide How to: Ruin a perfectly good C10
‘70 Blazer ConversionHow To: Ruin a Perfectly Good 4wd
'72 Highlander How To: Ruin a Perfectly Good K/5 (SOLD)
'72 Blazer 2WD How to: Ruin a perfectly good Blazer (SOLD)
'05 Yukon Daily Driven (not so stock) Yukon (SOLD)
‘07 Yukon Denali (daily)
Members met list: SCOTI, darkhorse970, 67cheby, 67cheby'sGirl, klmore, porterbuilt, n2billet, Fastrucken, classicchev, Col Clank, GSFMECH, HuggerCST, Spray-Bomb, BACKYARD88, 5150, fine69, fatbass, smbrouss70, 65StreetCruiser, GAc10boy
|