The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

tucks69 · 02-20-2009, 05:38 PM

I am planning to z the frame on my 62 C10. I notice it has a square frame where i am going to cut it. I thought most of them were channel. Since it is already a box, can I just weld gussets in the z and plates on both sides? I plan on a c notch also and it has brace on both sides as well.

Thanks
Michael

02-20-2009, 05:38 PM	#1
tucks69 Registered User Join Date: Dec 2008 Location: Hamlet NC Posts: 39	"Z" ing 62 frame I am planning to z the frame on my 62 C10. I notice it has a square frame where i am going to cut it. I thought most of them were channel. Since it is already a box, can I just weld gussets in the z and plates on both sides? I plan on a c notch also and it has brace on both sides as well. Thanks Michael