The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

forestb · 02-21-2009, 07:12 PM

Well I did it. I took 1.5 inches off the front by loosening the torsion bars. That plus the 2.5 inch drop spindles and the _ Inches that I have lowered it in the past should put me some where around 5 inches in the front. I hope it is still driveable I haven't taken it for a spin yet. Also I hope it makes it down my driveway. Does it really mater if you can not fit your jack under the cross member or not? I'm also planing in putting tiers or weals in the rear that are 2 inches taller than the ones that are on there now. So that It will be one inch higher in the rear to give me a little bit more of a forward tilt.If anyone has any suggestions let me know. Also if anyone knows of a place that sells rear sway bars for a 62 I would also like to know.

02-21-2009, 07:12 PM	#1
forestb Registered User Join Date: Jan 2009 Location: Burbank, CA Posts: 3,626	1.5 inches off the torsion bars. Well I did it. I took 1.5 inches off the front by loosening the torsion bars. That plus the 2.5 inch drop spindles and the _ Inches that I have lowered it in the past should put me some where around 5 inches in the front. I hope it is still driveable I haven't taken it for a spin yet. Also I hope it makes it down my driveway. Does it really mater if you can not fit your jack under the cross member or not? I'm also planing in putting tiers or weals in the rear that are 2 inches taller than the ones that are on there now. So that It will be one inch higher in the rear to give me a little bit more of a forward tilt.If anyone has any suggestions let me know. Also if anyone knows of a place that sells rear sway bars for a 62 I would also like to know. Attached Images Last edited by forestb; 02-21-2009 at 07:28 PM.