The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - old burban stolen, and questions about turn signal wiring on new burban

DRASTiK · 03-11-2003, 12:54 PM

well my 89 burban was stolen from my driveway two nights ago. It had a lot of valuables inside it, and it's probably in a chop shop in Mexico somewhere!!!!

anyways, I went and got an 84 1/2 ton 4x4 burban yesterday, and the turn signals don't work properly. If I cut the left blinker on, it works fine, but when I cut the right blinker on, the LEFT one comes on again. In other words, all I have is a left turn signal and no right signal. I don't have a wiring diagram for this year yet and I was hoping someone out there could help me out with this problem. What wires am I looking for. I'm assuming that they are crossed somewhere or maybe the switch has gone bad. Any thoughts are appreciated.

Thanks in advance,
Dave

03-11-2003, 12:54 PM	#1
DRASTiK Converted Ford guy Join Date: Nov 2002 Location: Yuma, AZ Posts: 67	old burban stolen, and questions about turn signal wiring on new burban well my 89 burban was stolen from my driveway two nights ago. It had a lot of valuables inside it, and it's probably in a chop shop in Mexico somewhere!!!! anyways, I went and got an 84 1/2 ton 4x4 burban yesterday, and the turn signals don't work properly. If I cut the left blinker on, it works fine, but when I cut the right blinker on, the LEFT one comes on again. In other words, all I have is a left turn signal and no right signal. I don't have a wiring diagram for this year yet and I was hoping someone out there could help me out with this problem. What wires am I looking for. I'm assuming that they are crossed somewhere or maybe the switch has gone bad. Any thoughts are appreciated. Thanks in advance, Dave __________________ 84 Suburban Silverado 4X4, 4" lift, flowmaster exhaust Marine Corps vet -- SEMPER FI Rice Haters Club Member #75 Last edited by DRASTiK; 03-11-2003 at 01:08 PM.