The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Longhorn Man · 03-07-2009, 05:54 PM

you might have to drill new holes for the tranny cross member, run new pipes, or have your old ones reworked a bit, relocate shifter linkage a tad... HEI will fit, but it'll be tight (assuming small block, big block might not have the room needed for HEI)

03-07-2009, 05:54 PM	#2
Longhorn Man its all about the +6 inches Join Date: Jan 2001 Location: Hilliard Ohio Posts: 2,690	Re: Moving motor perches you might have to drill new holes for the tranny cross member, run new pipes, or have your old ones reworked a bit, relocate shifter linkage a tad... HEI will fit, but it'll be tight (assuming small block, big block might not have the room needed for HEI) Last edited by Longhorn Man; 03-07-2009 at 05:55 PM.