The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**jaros44sr** · 04-03-2009, 06:56 AM

I think I found a new way(for me) to clean, derust, and paint parts with zero time and effort. Time spent was in the painting process, which I would've done anyway. I didn't use a high build primer, which would have removed the pits, but I did use a etching primer. So, for me, I will be saving my compressor for my air tools

Keep in mind that this build is not for show, just a clean daily driver. That is why I don't put the time and effort into making parts purdy, just no rust!

Everything is assembled with anti-seize, I won't be around to take it apart, but the next owner will thank me

04-03-2009, 06:56 AM	#1011
jaros44sr Senior Member Join Date: May 2006 Location: Philadelphia, Pa. 19454 Posts: 9,856	Re: PO has me PO'd I think I found a new way(for me) to clean, derust, and paint parts with zero time and effort. Time spent was in the painting process, which I would've done anyway. I didn't use a high build primer, which would have removed the pits, but I did use a etching primer. So, for me, I will be saving my compressor for my air tools Keep in mind that this build is not for show, just a clean daily driver. That is why I don't put the time and effort into making parts purdy, just no rust! Everything is assembled with anti-seize, I won't be around to take it apart, but the next owner will thank me __________________ Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim Last edited by jaros44sr; 04-03-2009 at 07:05 AM.