The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Longhorn Man · 04-09-2009, 10:29 PM

I would grab a factory 4 speed high hump from a truck in the junk yard, and then trace it's pring on the floor, then measure in one inch from that line and cut the hole out. mark and drill the holes and bolt it in with some sealer to seal it up.

04-09-2009, 10:29 PM	#2
Longhorn Man its all about the +6 inches Join Date: Jan 2001 Location: Hilliard Ohio Posts: 2,690	Re: sm465 in a 68 panel ? I would grab a factory 4 speed high hump from a truck in the junk yard, and then trace it's pring on the floor, then measure in one inch from that line and cut the hole out. mark and drill the holes and bolt it in with some sealer to seal it up.