The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Bell housing to connect NV4500 to 1964 305 V6?

64Fleetside4X4 · 05-15-2001, 08:24 PM

Hello all,

OK I know this one is a reach, but I just lost 1st and reverse in my 3 on the tree no synchro first tranny in my 1964 GMC Fleetside short bed 4X4. Divorced T-case. It's pretty good timing as it's spring and I was planning to swap to an NV4500 at some point. The motor still runs well and I'm not prepared to swap it at the same time as the tranny, so I'll take the hit on the bell housing to mate the NV4500 to my old 305 V6 - then when time comes I'll swap out the motor for a chevy 350.

Anyone know of an outfit that makes or modifies bell housing to fit this application? NV4500 to 1964 GMC 305 V6 with a divorced T-case (should make it easier).

------------------
Greg Kersten

05-15-2001, 08:24 PM	#1
64Fleetside4X4 Registered User Join Date: May 2001 Location: San Francisco, CA, USA Posts: 3	Bell housing to connect NV4500 to 1964 305 V6? Hello all, OK I know this one is a reach, but I just lost 1st and reverse in my 3 on the tree no synchro first tranny in my 1964 GMC Fleetside short bed 4X4. Divorced T-case. It's pretty good timing as it's spring and I was planning to swap to an NV4500 at some point. The motor still runs well and I'm not prepared to swap it at the same time as the tranny, so I'll take the hit on the bell housing to mate the NV4500 to my old 305 V6 - then when time comes I'll swap out the motor for a chevy 350. Anyone know of an outfit that makes or modifies bell housing to fit this application? NV4500 to 1964 GMC 305 V6 with a divorced T-case (should make it easier). ------------------ Greg Kersten __________________ Greg Kersten 64 GMC Fleetside Short Bed 4X4