|
Re: Eaton rear axle inspection plate
Like I said: 50/50 chance and what do ya know? I didn't notice it till I was filling up and thought WOW that fill hole is awful high!
Anyway I pulled it off and started over ..............now it's right. Pays to take a second look always. I was so concerned about getting permatex everywhere and in every hole and on every bolt to stop the drip from the cover that I tripped right into the trap!!!!! 
__________________
69 K-20 cloned to a 67 with front clip and some other stuff.
383 .040 over
Crane roller cam lifters and rockers ,1.6 intake ratio, Open chamber heads, 9.5-1 compression ratio, 2.02 intake valves , Edelbrock performer Air Gap manifold Carter AFB performer 750cfm, MSD ignition, SM465 NP205 4.10 gears: 
|