The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Wrenchbender Ret · 04-19-2009, 12:15 PM

Put a can of Sea-Foam in the gas tank. Open the idle jets up about a turn or 2 CCW. Run the engine a bit & slowly turn the idle jets in till the engine starts slowing down, then back them out about a 1/2 turn. If that doesn't cure it & you don't have vacuum leaks like previously suggested, the float level may be too low.

04-19-2009, 12:15 PM	#7
Wrenchbender Ret Registered User Join Date: Oct 2005 Location: Overland Park, Ks. Posts: 5,229	Re: Qjet accelerator pump Put a can of Sea-Foam in the gas tank. Open the idle jets up about a turn or 2 CCW. Run the engine a bit & slowly turn the idle jets in till the engine starts slowing down, then back them out about a 1/2 turn. If that doesn't cure it & you don't have vacuum leaks like previously suggested, the float level may be too low.