|
Re: Eaton rear axle inspection plate
Quote:
Originally Posted by 4x4Poet
If you perfectly place the cover on with the drain hole high, it will hit the ring gear.
|
It didn't seem to in my case or perhaps that would have tipped me off. I have the 4:10 if that is a different diameter perhaps???? Regardless, I didn't run it till I turned it back over to the correct position. Only took another hour to remove and start over. Some of my leak comes from the pinion seal I do believe. The worst thing bout em is that the bolt holes go straight through and if threads aren't gooped up good the oil seeps through the bolt holes!!
__________________
69 K-20 cloned to a 67 with front clip and some other stuff.
383 .040 over
Crane roller cam lifters and rockers ,1.6 intake ratio, Open chamber heads, 9.5-1 compression ratio, 2.02 intake valves , Edelbrock performer Air Gap manifold Carter AFB performer 750cfm, MSD ignition, SM465 NP205 4.10 gears: 
|