|
Scribe a line 4" from the rear lip of the floor. Scribe a second line 12" from the rear lip of the floor. The 2 scribe lines indicate the 8" you will remove.
When cutting like Kid described you will need to drill new holes to be able to bolt the header panel & bedsides on. The front will also not have the factory tapered appearance (in case this matters to you).
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|