The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Gene · 06-06-2009, 03:00 PM

Well, now that I thought about it, I already have the front brackets bolted on in the place of the front cab supports. So all I have to do is install the rear bracket, and if i'm correct from all the digging I have done, I use the bottom rivet hole as a guide as to where to put the rear shackle support. I'm guessing after that I use the template DIY sent, so all i'm worried about is that the axles are centered and the front bracket is what locates that right?
Also, i'm trying to decide the best way to cut the hole, is a holesaw the best route, and do I go with a 2 inch or larger?

06-06-2009, 03:00 PM	#3
Gene Registered User Join Date: Aug 2002 Location: Muskogee, Oklahoma Posts: 2,914	Re: FGB52 help Well, now that I thought about it, I already have the front brackets bolted on in the place of the front cab supports. So all I have to do is install the rear bracket, and if i'm correct from all the digging I have done, I use the bottom rivet hole as a guide as to where to put the rear shackle support. I'm guessing after that I use the template DIY sent, so all i'm worried about is that the axles are centered and the front bracket is what locates that right? Also, i'm trying to decide the best way to cut the hole, is a holesaw the best route, and do I go with a 2 inch or larger? Last edited by Gene; 06-06-2009 at 03:01 PM.