The next set of pics are the stainless air and brake lines. The airlines are complete except that I have to connect two lines from the takes to the valve manifolds.
This pic shows the lines going out to the bags. All lines are 1/4 inch.
Here is where the two airlines go around the notch. This is the same on both sides. One line is for the rear bag, and the other line is for the front bag. In this pic, you will also see the brake lines. Notice the line on the top round bar. I STOLE this idea from Scotts Hot rods. No more lines on the axle. Nice and clean. Thanks Scotts! Oh, I am using AN fittings here. A braided stainless line will connect to this fitting to the caliper.
This is the other side. Sorry for the blurry pic. The clips are freakin awesome. They are from made4u.
This is one of the rear bags.
