View Single Post
Old 06-14-2009, 05:04 AM   #8
Rack Man
Registered User
 
Join Date: Sep 2008
Location: Tempe, AZ
Posts: 770
Re: New Radiator Issue

I had the same exact problem...I notched out the core surpport a bit where the bottom "holder" goes to allow it to sit down a bit further.....Not perfect but not too bad...also, once you start tightening down the top brackets it will seat in the rubber a bit too....

One other problem I had was the fins on the new radiator wasn't allowing the fan shroud to sit flat...so I had to grind them down on both sides as well!

Btw, my mounts were all original....it was all in the radiator....I had my original radiator there for comparison.

Dan
__________________
My Build Thread: http://67-72chevytrucks.com/vboard/s...d.php?t=309288

Last edited by Rack Man; 06-14-2009 at 05:07 AM.
Rack Man is offline   Reply With Quote