The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

68 short step · 06-14-2009, 09:54 AM

a little progress to report, started smoothing the firewall.....and only found a little rust over the blower motor hole (easy fix), but other then that it was very clean and solid....
cut original heater holes out, made my templets, transfered to 16ga. sheetmetal, cut/fit, then weld and grind....

06-14-2009, 09:54 AM	#50
68 short step Senior Member Join Date: Aug 2005 Location: tulsa OK Posts: 3,070	Re: project BIG RED (gen3 on air) a little progress to report, started smoothing the firewall.....and only found a little rust over the blower motor hole (easy fix), but other then that it was very clean and solid.... cut original heater holes out, made my templets, transfered to 16ga. sheetmetal, cut/fit, then weld and grind....