Re: Thanks for asking.....here is project: Patina'd
And now onto the fender wells. Basically, what I did was take about 2/3rds of one and 2/3rds of another and weld them together. First you have to get an extra set of fender wells. If I had to do it over again I'd try to find either 4 cherry ones or buy 4 aftermarket ones. Was in a hurry to get it on the road 2 years ago so this is what I would up with.
First thing I did was to take what would be the outer wells and cut it as square as I could, just taking off the part that would bolt to the side of the bed. next, I put the original fenders in their original place and set the other fenders on top of them and move them out to where they would be on the low part of the bed floor. I simply took a sharpie and drew a line on the inside well using the edge of the outside one I just cut. I took the inside ones and cut them the same way with a cut off wheel. When I put both halves back on the bed floor. I was please with how well they fit together.
Last edited by prostreetC-10; 06-19-2009 at 10:26 AM.
|