|
Re: I need some help choosing headers...help please!
I have some cheapy flowtech headers and the collector runs under the bellhousing crossmember, they fit well and don't interfere with my clutch linkage. I think these would be too low for laying frame. From what I've seen of the full length headers they all run this way, so you might be stuck with shortys or block huggers (not sure how these fit with steering/clutch). Good luck, maybe some of the bagged guys will let you know what they're running.
__________________
68 3/4 ton  (Project)-350 Small Block, .030 over, 10:1 comp, 3998993 heads, C3BX edelbrock intake, comp cams XE268, Holley 670 SA, long tube headers, dual flow 40's, E-fan, Alum rad, currently under the knife getting shortened and bagged  build thread
41 3/4 ton (wife's)-flatbed, fully restored to original
01 Tahoe LT 4WD (my daily driver)-Magnaflow Muffler, Rollin on 22's
02 Ford Mustang Convertable (Wife's Car)-Flowmaster 50, Clear corners, Intake, sittin on 18's
|