The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Fred T · 07-20-2009, 10:11 AM

I'm having trouble figuring out what y'all are describing.

Is this on your 50 GMC? And this the door glass, that gets cranked up and down? And you're saying that there is a gasket around the perimeter, the sides and top edges of the glass?

If so, I have never seen such a gasket. It could have been added by a po. These trucks had the window seals in the door. Only rubber attached to the glass was the set tape used to hold the glass in the channel at the base. Can you show a photo?

07-20-2009, 10:11 AM	#2
Fred T Cantankerous Geezer Join Date: Aug 2002 Location: Bel Aire, KS Posts: 6,264	Re: 1rst series door glass replacement I'm having trouble figuring out what y'all are describing. Is this on your 50 GMC? And this the door glass, that gets cranked up and down? And you're saying that there is a gasket around the perimeter, the sides and top edges of the glass? If so, I have never seen such a gasket. It could have been added by a po. These trucks had the window seals in the door. Only rubber attached to the glass was the set tape used to hold the glass in the channel at the base. Can you show a photo? __________________ Fred There is no such thing as too much cam...just not enough engine.