|
Re: DO NOT OPEN- Air Ride Technologies inside
Phase II-
The second phase of this project is finally underway. Due to logistics, it was deemed impractical to do the install of this system in my garage. Don't get the impression that it couldn't be accomplished by average Joe trucker in your own garage. In the interest of writing this article, it necessitates the bed being removed from the truck to properly document the procedure. That would require an amount of space that I didn't have available.
As previously mentioned my buddy Keith, and Roger agreed that they had space to do the job at Rogers new shop. Now that his facility was set up with plenty of lighting and a new whizz-bang state of the art security system, it was time to move forward.
I carefully loaded the Cheyenne's bed to capacity with all of the goodies from A.R.T. Since Rogers shop is a 4 hour drive from my house, it was decided to trailer the truck rather than drive two vehicles. This turned out to be a good decision. While stopped for a round of refreshments, I checked the load on the rental trailer and noticed brake fluid dripping in my rear wheel. It seems that one of the rear wheel cylinders decided to let go.
|