[ol Curt]

Getting near the end on the floor. Made a quasi patch panel for the passenger side kick panel out of an old piece of sheet metal from a farm implement.

Now I started to remove a couple of seat bolts that I thought were coming out nicely when they snapped off. I tried several methods....welding a bolt to it and trying to get it out. Couldn't get a good ground and the weld would always break. Used an easy out and it was budging some....broke off the easy out! Next I just cut the section of the floor surrounding it out. After looking at it I wonder if I welded a piece of bar steel to the floor patch, welded patch to floor, marked seat hole, drill and then tap if that would work. Any thoughts?