The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Speedster 229 · 04-03-2003, 05:18 PM

I have disassembled my front suspension on my 70 1/2 ton 2WD and had all parts powder coated. I'm ready to reassemble and I'm wondering how tight the end bolts on the A Arm shafts need to be. They were very difficult to get appart. I have purchased a rebuild kit from PST and I don't know how to tell when they are in far enough. Is there a torque spec? Any and all advice will be greatly appreciated.

04-03-2003, 05:18 PM	#1
Speedster 229 Registered User Join Date: Oct 2002 Location: Spokane Wa. Posts: 36	Help with A arm shaft end bolts/bushings I have disassembled my front suspension on my 70 1/2 ton 2WD and had all parts powder coated. I'm ready to reassemble and I'm wondering how tight the end bolts on the A Arm shafts need to be. They were very difficult to get appart. I have purchased a rebuild kit from PST and I don't know how to tell when they are in far enough. Is there a torque spec? Any and all advice will be greatly appreciated.