Quote:
Originally Posted by John Fabris
For the sake of doing mininmal work to these doors for the purpose of just to get you by until you get new doors, take a good wire brush and scrub inside to knock off any scale, and then use a brush and something like POR15 or RustMort and coat the rusty areas inside the doors. Also make sure along the bottom of the doors that the small drain vents are open (to allow rain water to drain from the doors.
On out side of doors, clean area with grease remover, sand rusty area to remove surface rust, clean again and spray with a rust prohibiting primer. Then start looking for new doors.  |
I agree. Yoo need to coat the insides and outsides with something that will stop the rust you do have and prevent more rust from forming. Most people swear by POR15.