The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Building a Blazer

vtblazer · 08-22-2009, 07:17 PM

Don't care...
Can't stand to see it sitting in my garage and not work on it, so I did.

Started in on the firewall, got after a couple of the holes that need patching (3 more to go) and began sanding it down for paint.

Found a ton of debris in the pass. side cowl, will drill more holes on the bottom for better drainage before I paint.

Have two differant name brand drivers side rockers, will decide which one to use when I get to pulling off the existing rocker.
Yeah, it was just bad enough to convince me to replace it.

08-22-2009, 07:17 PM	#633
vtblazer Registered User Join Date: Oct 2003 Location: Central Vermont Posts: 8,537	Re: Building a Blazer - vtblazer's Way Don't care... Can't stand to see it sitting in my garage and not work on it, so I did. Started in on the firewall, got after a couple of the holes that need patching (3 more to go) and began sanding it down for paint. Found a ton of debris in the pass. side cowl, will drill more holes on the bottom for better drainage before I paint. Have two differant name brand drivers side rockers, will decide which one to use when I get to pulling off the existing rocker. Yeah, it was just bad enough to convince me to replace it. Attached Images Last edited by vtblazer; 08-22-2009 at 07:18 PM.