Re: Trailing Arm Bushings!!!!
Quote:
Originally Posted by AusTx68
My poly bushings required the outer shell which made it easier on me to replace. All I did was drill holes into the rubber between the shell and inner bolt sleeve. Didn't take long. I made like 8 or 9 holes then stuck a big screw driver in the bolt sleeve and pryed it out. I then used a wire brush to clean out the shell.
|
I've taken out bushings this way as well.
__________________
83 C10 Stepside (SOLD, it was a blast!)
383 MASS-FLO EFI/TKO II 600/3.90 Posi 10 bolt
S475 and C4 DM running, fine tuning
turbo= 
Douchebag Racing: Runs Fine all the Time
|