The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

markeb01 · 09-09-2009, 01:11 AM

You might want to review the following link for additional opinions:
http://67-72chevytrucks.com/vboard/s...&highlight=por

I used POR-15 on my current truck and wouldn't use it again. It was prepped as suggested back when, but it hasn't held up that well showing quite a few rust pits here and there. My previous ride was a 46 Ford sedan. I coated the chassis with the rust converter that Eastwood now sells, followed by hardened acrylic enamel and it looked like new after 8 years and 300,000 miles. If I were doing my truck over today I would probably do the chassis with Zero Rust (assuming it's for a driver vehicle).

09-09-2009, 01:11 AM	#3
markeb01 Senior Enthusiast Join Date: Feb 2007 Location: Spokane Valley, WA Posts: 8,356	Re: Chassis Paint You might want to review the following link for additional opinions: http://67-72chevytrucks.com/vboard/s...&highlight=por I used POR-15 on my current truck and wouldn't use it again. It was prepped as suggested back when, but it hasn't held up that well showing quite a few rust pits here and there. My previous ride was a 46 Ford sedan. I coated the chassis with the rust converter that Eastwood now sells, followed by hardened acrylic enamel and it looked like new after 8 years and 300,000 miles. If I were doing my truck over today I would probably do the chassis with Zero Rust (assuming it's for a driver vehicle).