The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**lks dcvn** · 09-23-2009, 01:37 PM

When you get the replacement boxes there is a bar in them already...so by replacing them you will get both.

Also if you are going to do body work on a blazer - you need to follow a few steps:

1. Don't take the top off until after the body work is done
2. Replace the Body Mounts if they are rotted/gone prior to starting
3. Brace up the door openings (and take measurements) to make sure the firewall doesn't sag if the body is weak when you start cutting out metal.

09-23-2009, 01:37 PM	#6
lks dcvn Registered User Join Date: Jan 2007 Location: Columbus, Ohio Posts: 4,352	Re: rocker box question When you get the replacement boxes there is a bar in them already...so by replacing them you will get both. Also if you are going to do body work on a blazer - you need to follow a few steps: 1. Don't take the top off until after the body work is done 2. Replace the Body Mounts if they are rotted/gone prior to starting 3. Brace up the door openings (and take measurements) to make sure the firewall doesn't sag if the body is weak when you start cutting out metal.