The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

MOTHERTRUCKERS · 04-12-2003, 07:54 AM

Just drilling will not work you have to heat it with a torch and pull the inner shaft out and clean it up then put it back in, adjust it to length then drill a new hole and put a roll pin in it. We have lengths of 3/4" DD shafts in stock if you need a longer inner shaft.

04-12-2003, 07:54 AM	#4
MOTHERTRUCKERS Registered User Join Date: Dec 1999 Location: BRADENTON FLA Posts: 3,269	Just drilling will not work you have to heat it with a torch and pull the inner shaft out and clean it up then put it back in, adjust it to length then drill a new hole and put a roll pin in it. We have lengths of 3/4" DD shafts in stock if you need a longer inner shaft. __________________ Rest in Peace Ed. Thanks for all the good times.