I didn't realize what a pain this project would be to swap the body mounts and bolts...
Except for the last two (position 5 at the tailgate) bolts - I had to drill out the head on each of the bolts and then bang them through from the top. I attached a pic of what I was working with - yikes.
I started at 9am and quit for dinner and trick or treaters around 6.
So in that time I got 9 of the 10 replaced (I have the driver floor mount to do yet tomorrow).
Each mount got a layer of rust prevention paint and then put back together. I attached a fex pix during the process and a few that are done waiting to be tightened up.
Right now the psgr door won't latch so it will need to be checked for alignment/shimming...
Once I see how the both doors open/close I will shim accordingly, tighten up the mounts and then check out the rust repair needs -