The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Mike Bradbury · 10-31-2009, 11:50 PM

This is what I was thinking, I would rather be a bit to overkill than a bit to linguine. Since I am still in the design stage I still may cut the joint and put a heim joint in place.
Before I asked my question I did some research and came across many opinions on the forum about Heims and how they make it louder and they tend to wear quicker. But they do make a less binding set-up. I am also planing on mounting Bilstein coil overs to the ends of the arms behind the axle.
Thanks for the advice, Any body else?

10-31-2009, 11:50 PM	#6
Mike Bradbury Registered User Join Date: Apr 2008 Location: San Diego California Posts: 1,316	Re: Is my DOM too thick? This is what I was thinking, I would rather be a bit to overkill than a bit to linguine. Since I am still in the design stage I still may cut the joint and put a heim joint in place. Before I asked my question I did some research and came across many opinions on the forum about Heims and how they make it louder and they tend to wear quicker. But they do make a less binding set-up. I am also planing on mounting Bilstein coil overs to the ends of the arms behind the axle. Thanks for the advice, Any body else? __________________ I'd rather attempt something great and fail.. than try something ordinary and succeed. Norman Vincent Peale Project: Barn Raising http://67-72chevytrucks.com/vboard/s...d.php?t=414961 Project: 30 Be Low https://67-72chevytrucks.com/vboard/...d.php?t=830583 Last edited by Mike Bradbury; 10-31-2009 at 11:52 PM.