Quote:
Originally Posted by OrrieG
Just noticed you said you have an assy manual. Look at section 5 sheet 12. View B at the top shows the shaft and the retainer clip and bolt. Removing the bolt and clip will allow the shaft to come out. If it has not been lubed in may be corroded or seized to the arm. Check the cast piece that holds the shaft for cracks that would let is spread. If you have as much play as you say, any problem should be obvious.
|
ok I'll get back under there and take a look. When I replaced the master cylinder I pulled everything apart and made sure it was lubed but maybe I didn't get that tight enough.