The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

cparman · 12-12-2009, 10:37 PM

My Blazer had an HEI in it when I bought it. I have a bunch of clearance??? Her is a poor pic of it. I think I can get my hand around it no problem. Oh yea, i used a set of Taylor wires that I cut to length. I ran the front two on both sides under the motor mount. ( like a Corvette with HEI ) I have done this a bunch of times with Rams horn manifolds. Looks good, and makes teh wire set look very neat.

12-12-2009, 10:37 PM	#16
cparman sharp as a marble Join Date: Jan 2007 Location: atlantic beach,florida Posts: 1,082	Re: HEI dist in 4x4 72 Jimmy/Blazer My Blazer had an HEI in it when I bought it. I have a bunch of clearance??? Her is a poor pic of it. I think I can get my hand around it no problem. Oh yea, i used a set of Taylor wires that I cut to length. I ran the front two on both sides under the motor mount. ( like a Corvette with HEI ) I have done this a bunch of times with Rams horn manifolds. Looks good, and makes teh wire set look very neat. Attached Images Last edited by cparman; 12-12-2009 at 10:48 PM.