[padresag]

Originally Posted by Tx Firefighter

The 6 and small block frame mounts are quite different.

Here are some pictures I took to compare the two...

there is something screwy with these pictures
this is the drivers side frame. all frame perches for the drivers side are the same. the rear one looks correct for 63-66. it fit in the frt set of holes for a 230-250 i6 and the rear 2 holes for a 283 for a stk application. not sure which holes the 292 mounts to as there is an offset from one side to the other, but is the same perch.
the front one looks like a pass side perch moved over as it flows the wrong way, unless it comes off of a later model(which I am not familiar with).
no wonder that there is so much confusion about these mounts
ron