The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

*2tons of fun* · 12-31-2009, 02:21 AM

dont need to but you can.

i have swapped the m/c both time becuase the m/c was shot on both trucks i have done this to.

if anything you should swap out the diverter/prop valve, on the drum drum setup it was split 50/50 because the front couldnt take as much as disc can. just grab the one from the donor, it will have 2 lines for the front instead of one but you can just block the one off. last time i replumed the whole system and ran all 3 lines fromt he factory mount next to the master. this time i am going to mount the prop ont he crossmember like 73+ and run them from there, it will save some tube and look cleaner.

i am going to keep the small booster on this truck to clear the valve covers better but the last truck had te bigger booster.

12-31-2009, 02:21 AM	#7
2tons of fun Account Suspended Join Date: Jan 2009 Location: galt ca, Posts: 749	Re: front cross member change out? dont need to but you can. i have swapped the m/c both time becuase the m/c was shot on both trucks i have done this to. if anything you should swap out the diverter/prop valve, on the drum drum setup it was split 50/50 because the front couldnt take as much as disc can. just grab the one from the donor, it will have 2 lines for the front instead of one but you can just block the one off. last time i replumed the whole system and ran all 3 lines fromt he factory mount next to the master. this time i am going to mount the prop ont he crossmember like 73+ and run them from there, it will save some tube and look cleaner. i am going to keep the small booster on this truck to clear the valve covers better but the last truck had te bigger booster.