[Twisted78SS]

I finally did get out to my shop and do some work on one of my trucks. The 71 4x4 I bought awhile back had an inop heater, so I dug into it and found both a bad switch and a frozen cable. I decided to pull out the entire assembly and clean it while I repaired it, but I found once I got it out, that all the rivets holding it together were toast and it was falling apart. I had another control set from my Blazer, so after cleaning and lubricating all the cables and testing the switch on it, I installed it back in the truck.. Nice to have working heat!! I also began to clean up the NP 205 in preparation for new seals and a transplant from 4 spd to automatic. Now I just have to gather up my flex plate, starter, and a few other goodies..