[DKN]

Some more FAQ's:

The crossmember has 3-3/8" by 5" oval holes so you can easily tuck 3" exhaust up above the bottom of the frail rail.

There is an optional bracket that allows you to use the 2 piece drive shaft. The bracket and carrier bearing are shown in the photot Jeff posted.

There are provisions for your parking brake cables in both the crossmember and the tubular trailing arms.

If you tucked up the exhaust by adding the CPP trans crossmember, and used the CPP tubular lower control arms in the front the lowest point on the truck will become the U-bolts that mount the front control arm cross shafts.

This set up on air bags is killer when it sits that low.

Danny Nix
CPP