[thrtsxchambers]

To make sure I have this question right. Are you asking about sectioning the bumper to pull the sides closer or pushing the bumper in closer all the way across the front. There are two response that are about two different ways. I have seen both done and plan on both on my truck. I think to push the bumper you can unbolt it and slide it back and remount it to the frame horn, I don't you have to cut the horn but I have not check close on mine. To section it is just like sectioning a body__ measure, mark, cut, weld, sand, rechrome, install. If you are buying a bumper and sectioning it order a raw steel bumper b/c they are cheaper and you will have to have it chromed after the welding.