a little past due but im just about finished the rocker panel on the passenger side. didnt line up great at all, had to splice, weld from the backside on some areas instead of spot weld...but i think it turned out ok. gonna need some filler but i think it will look good. heres a few shots..
the gap toward the front was a little smaller, so before i put some spot welds i pulled it down and it helped a lot...at least it looks better to me lol. the gap looks a little funny in the pic, but its the angle of the shot. i do want to get my gaps a little tighter when its all said it done, but thats long from now, probably just before paint. the factory has horrible gaps on these rigs...
and this is what i have to figure out. it doesnt contour the a pillar very good, so i might have to splice it there or just cut up some scrap metal and fill it in...any ideas?
thats it for now. gonna finish that litle section in the morning and then i will probably start ripping into the driver side.
__________________
67 1/2 ton Suburban - Project DRGNWGN.
Build thread 
-_--_--_ _________
_--_-_ -/____|__|__\__
,.,,,.,.,,.,|_O _______ O_]