The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

hotrodrookie · 02-27-2010, 04:03 AM

This was a simple 45 min modification. I had a piece of scrap, bent it over a pipe slightly in 2 directions, traced it from the inside of the hole, snipped it, ground it, welded it.

02-27-2010, 04:03 AM	#8
hotrodrookie Registered User Join Date: Sep 2008 Location: Sacramento Posts: 425	Re: 56 gas filler pacth panel? This was a simple 45 min modification. I had a piece of scrap, bent it over a pipe slightly in 2 directions, traced it from the inside of the hole, snipped it, ground it, welded it.