Engine twisted in the frame?
I'm swapping in an LT1 which has plenty of flat technically level area on top. If I place a straightedge across the top and measure down from the straightedge the drivers side is 1 in closer to the frame than the same point on the passenger side. 1963 C-10 straight six motor mounts used.
My question is thus; Should the top edges of the frame where the top of the engine mount attaches be equal distance?
This all arose from the 1967 C-10 headers I bought having the number 1 primary hit the engine mount.
Thanks in advance,
- Brian
__________________
1963 Long Bed C10 - LT1/4L60E Swap in Progress. Blew up the straight six and happened to have the engine trans combo on hand already.
1995 Impala SS - LT1/T56 Combo. This is my 1st priority project.
|