The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - How Did You Finish Your Serpentine Brackets???

es67chevy · 03-08-2010, 04:54 PM

We bought a GM Performance serpentine setup for our truck and the aluminum brackets do not look the best. There are a lot of nooks and crannies in the brackets that make them hard to polish or paint, etc. So, what did you do to your brackets? Did you leave them as they came? Did you paint them? Powder coat them? Pictures are helpful if you have any. And any tips on what didn't work for you if results were less than satisfying.

Here is what our setup looks like mocked up without any finishing done to the aluminum brackets:

03-08-2010, 04:54 PM	#1
es67chevy Registered User Join Date: Aug 2007 Location: Bella Vista, AR Posts: 1,107	How Did You Finish Your Serpentine Brackets??? We bought a GM Performance serpentine setup for our truck and the aluminum brackets do not look the best. There are a lot of nooks and crannies in the brackets that make them hard to polish or paint, etc. So, what did you do to your brackets? Did you leave them as they came? Did you paint them? Powder coat them? Pictures are helpful if you have any. And any tips on what didn't work for you if results were less than satisfying. Here is what our setup looks like mocked up without any finishing done to the aluminum brackets: __________________ Eric 1967 C10 SWB 383 Stroker/TH400 Brother's One Piece Power Windows Shaved Doors, Markers, and Bumpers 4/6 Early Classic Drop Rear Fuel Tank (49-52 Chevy Car Tank) Surf Blue Paint Bella Vista, AR (Arkansas for those that get the 'A' states mixed up) My Build Thread: http://67-72chevytrucks.com/vboard/s...d.php?t=330869