The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Raguemoe · 03-19-2010, 02:14 AM

Anyone have clearence problems with a aluminum (CPP) tank with a notched rear end. I stopped by the shop that's doing some work on my project truck and he installed the CPP tank I ordered. The truck has rally wheel while @ the shop so I know my 22" wheel bring up the back a little, but right now the fuel tank hits the ground a full 2" before the rear suspension bottoms out. Even if my wheels bring it up and inch or two and I put 2" bump stops, it whould be real close @drive height.

Anyone else run into this problem or have any ideas!

03-19-2010, 02:14 AM	#1
Raguemoe Junior Member Join Date: Jan 2007 Location: Highland CA Posts: 742	Aluminum Fuel tank on a Bagged Truck?? Anyone have clearence problems with a aluminum (CPP) tank with a notched rear end. I stopped by the shop that's doing some work on my project truck and he installed the CPP tank I ordered. The truck has rally wheel while @ the shop so I know my 22" wheel bring up the back a little, but right now the fuel tank hits the ground a full 2" before the rear suspension bottoms out. Even if my wheels bring it up and inch or two and I put 2" bump stops, it whould be real close @drive height. Anyone else run into this problem or have any ideas!