View Single Post
Old 04-03-2010, 08:50 PM   #4
packers05
Registered User
 
Join Date: Feb 2009
Location: minonk illinois
Posts: 224
Re: Need rear end work

I dont know your skill level but overall it is not to hard to do it just takes a very good shim selection and some patience, a dial indicator and inch pound torque wrench unless you can have someone experienced drop by and do a spin on the pinion and check it by feeling it and backlash is easy enough to check, but overall as long as you have the gear mesh right you will be fine. You will need an impact with nutz to tighten pinion nut enough to move the crush sleeve. All of this is assuming new bearings will be installed,good luck
packers05 is offline   Reply With Quote