Re: Project: Recycle
Quote:
Originally Posted by aggie91
Looks good Scoti. Are you going to use pieces from the other frame to make the 60 degress transitions back down to the OE frame? I would think that using them with the radius for the bend (top edge of the frame) would be consistant and would "flow" into the OE frame really well. Just a thought for you...
|
No.... Just going to use flat plate for the end pieces. I'll round the edges to mirror the inside corner of the notches (as much as possible anyway).
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|