View Single Post
Old 05-09-2010, 05:00 PM   #1
elwoods76
Just Cruizin
 
elwoods76's Avatar
 
Join Date: Jun 2008
Location: Pleasant Grove,Utah
Posts: 154
Drop Help- Went to low

Dropped the blazer yesterday with 3" springs and 3" spindles in the front and a flip out back. I can't get my 295-50-15 to clear up front and they barely clear in the back. I was thinking for the front I have a set of springs in my silver chev also pictured below that were cut one coil. So if I switch them around that might take care of issue for the front. But what can I do in the back and still have the flip on there????? I have maybe an inch and a half of clearance from frame to axle. I want to notch it down the road but not yet. Please help with ideas or solutions to my problem.
Attached Images
   
elwoods76 is offline   Reply With Quote