The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - One Piece Drive Shaft

Longhorn Man · 05-12-2010, 06:23 AM

it can be done, but you'll spend a lot of money for an inferier piece. Just get your stock shaft cut down and new U joints and a good carrier bearing and get it ballanced. Tell the drive shaft shop that it is now for an overdrive aplication too.

05-12-2010, 06:23 AM	#3
Longhorn Man its all about the +6 inches Join Date: Jan 2001 Location: Hilliard Ohio Posts: 2,690	Re: One Piece Drive Shaft - 72 long bed it can be done, but you'll spend a lot of money for an inferier piece. Just get your stock shaft cut down and new U joints and a good carrier bearing and get it ballanced. Tell the drive shaft shop that it is now for an overdrive aplication too.