The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

silversvs · 05-23-2010, 02:06 AM

Don't know if the 54 is the same as my 59, but I just replaced all the door glass this evening. I pulled the vent assembly most of the way out and then slid the window glass in at an angle. I then slid the window glass and vent assembly down into the door. I wiggled the vent assembly into place. Then used the window crank to put the regulator up where the sash upper channel was visible. Then I instaaled the two retaining screws and I was done. Sounds easier than it was but it only took about two hours start to finish to replace all the glass.

05-23-2010, 02:06 AM	#6
silversvs Registered User Join Date: Dec 2009 Location: Tracy CA Posts: 78	Re: Door Glass Don't know if the 54 is the same as my 59, but I just replaced all the door glass this evening. I pulled the vent assembly most of the way out and then slid the window glass in at an angle. I then slid the window glass and vent assembly down into the door. I wiggled the vent assembly into place. Then used the window crank to put the regulator up where the sash upper channel was visible. Then I instaaled the two retaining screws and I was done. Sounds easier than it was but it only took about two hours start to finish to replace all the glass.