The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

8mpg · 05-31-2010, 08:49 PM

The Miller 110 is plenty for the frame. It should do up to 3/16" steel on the highest setting. These frames are 1/8" or so. It will be fine. If you can, weld the inside and the outside seam.

You need to trust your welding more than the machine. When set properly, you shouldnt have any problems. Do a test piece and check your welding penetration

05-31-2010, 08:49 PM	#3
8mpg Registered User Join Date: Aug 2008 Location: DFW, Texas Posts: 389	Re: custom frame work The Miller 110 is plenty for the frame. It should do up to 3/16" steel on the highest setting. These frames are 1/8" or so. It will be fine. If you can, weld the inside and the outside seam. You need to trust your welding more than the machine. When set properly, you shouldnt have any problems. Do a test piece and check your welding penetration Last edited by 8mpg; 05-31-2010 at 08:50 PM.